555 Test Bed / Component tester / Cap dump

NE555 Duty Cycle And Frequency Adjustable Module Square Wave

Module Scope
1. Used as a square wave signal generator produces a square wave signal for the experimental development use. 
2. Used to generate the square wave signal to drive a stepper motor drive. 
3. Produce adjustable pulse for the MCU to use. 
4. Generating adjustable pulse to control the associated circuits. 

A brief description
1. Size: 3.5CM * 3.6CM 
2. The main chip: NE555; 
3. Input voltage: 5V-15VDC. 5V power supply, the output current can about 15MA; 12V power supply, the output current can be so 35MA; 
4. Input Current: ≥ 100MA 
5. Output amplitude: 4.2V V-PP to 11.4V V-PP (depending on the input voltage, the output amplitude is not the same) 
6. Maximum output current: ≥ 15MA (5V power supply, V-PP greater than 50%), ≥ 35MA (12V power supply, V-PP greater than 50%) 

Advantages
1. Output with LED indication, there is no output LED quantity (low straightforward, high level LED off relatively low frequency LED flashes); 
2. Output frequency range grade optional continuously adjustable output frequency; 
Low-frequency stall: 1Hz ~ 50Hz 
IF stall: 50Hz ~ 1kHz 
In the high-frequency stall: 1KHz ~ 10kHz 
High-frequency stall: 10kHz ~ 200kHz 
3. the output duty cycle can fine-tune the duty cycle and frequency is not adjustable separately adjust the duty cycle will change the frequency 
4. the output frequency is adjustable; 
Cycle T = 0.7*(Ra + 2*Rb)*C 
Ra, Rb:0-10K adjustable; 
LF gear C = 0.001UF; 
IF file C = 0.1UF; 
In the high-frequency file C = 1UF;, 
High-frequency gear C = 100UF, the waveform frequency buyers can own calculations. 



For the information: 

http://www.icstation.com/ne555-duty-cycle-frequency-adjustable-module-square-wave-p-2224.html